Kia Rio: Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
| 1. |
Run the engine for one or two minutes, and then stop it. If the
pedal depresses fully the first time but gradually becomes higher when
depressed succeeding times, the booster is operating properly, if the
pedal height remains unchanged, the booster is inoperative.
|
| 2. |
With the engine stopped, step on the brake pedal several times.
Then step on the brake pedal and start the engine. If the pedal
moves downward slightly, the booster is in good condition. If there
is no change, the booster is inoperative.
|
| 3. |
With the engine running, step on the brake pedal and then stop
the engine.
Hold the pedal depressed for 30 seconds. If the pedal height does
not change, the booster is in good condition, if the pedal rises, the
booster is inoperative.
If the above three tests are okay, the booster performance can
be determined as good.
Even if one of the above three tests is not okay, check the check
valve, vacuum hose and booster for malfunction.
|
Components
1. Brake booster
2. Master cylinder assembly
3. O-ring
...
Removal
1.
Turn ignition switch OFF, and disconnect the negative (-) battery
cable.
2.
Remove the battery and ECM.
(Refer to Engine Electr ...
See also:
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Brake pad
6. Pad retainer
...
Front Seat Belt Replacement
Front Seat Belt Replacement
•
When installing the belt, make sure not to damaged the
...
Rear Washer Motor Inspection
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
2.
Remove the front bumper cover. (Refer to t ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026