Kia Rio: Installation
Installation is in the reverse order of removal.
Perform the following :
| • |
Adjust a shift cable.
|
| • |
Refill engine with engine oil.
|
| • |
Refill a transaxle with fluid.
|
| • |
Refill power steering fluid.
|
| • |
Refill a radiator and a reservoir tank with engine coolant.
|
| • |
Clean battery posts and cable terminals and assemble.
|
| • |
Inspect for fuel leakage.
|
| - |
After assemble the fuel line, turn on the ignition switch (do
not operate the starter) so that the fuel pump runs for approximately
two seconds and fuel line pressurizes.
|
| - |
Repeat this operation two or three times, then check for fuel
leakage at any point in the fuel line.
|
| • |
Bleed air from the cooling system.
|
| - |
Start engine and let it run until it warms up. (until the radiator
fan operates 3 or 4 times.)
|
| - |
Turn Off the engine. Check the level in the radiator, add coolant
if needed. This will allow trapped air to be removed from the cooling
system.
|
| - |
Put radiator cap on tightly, then run the engine again and check
for leaks.
|
Removal
•
Use fender covers to avoid damaging painted surfaces.
...
Timing System
...
See also:
Radiator: Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, then
install it to pressure tester.
2.
Apply ...
Electric Oil Pump: Description
This transaxle has a standard Mechanical Oil Pump (MOP) linked to the
input shaft to generates oil pressure when input shaft rotates.
But, this transaxle equipped with ISG system also has ...
Removal
1.
Disconnect the brake fluid level switch connector, and remove
the reservoir cap.
2.
Remove the brake fluid from the master cylinder res ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026