Kia Rio: Brake Switch Description

The present brake switch is used as an input variable for the ISG function to detect bracke operation.

Oil Pump Unit (OPU) Inspection

OPU Problem Inspection Procedure 1. TEST OPU GROUND CIRCUIT: Measure resistance between OPU and chassis ground using the backside of OPU harness connector ...

Brake Switch Inspection

1. Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in an ...

See also:

Output Speed Sensor Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Components Operations
ECM (Engine Control Module) 1. The ECM(PCM) (A) carries out a check of the ignition key using a special encryption algorithm, which is programmed into the transponder ...

Rear Washer Motor Inspection
1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. 2. Remove the front bumper cover. (Refer to t ...