Kia Rio: Brake Switch Inspection

1.	Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in and when it is released.

2.	The stop lamp switch is in good condition if there is no continuity when plunger (A) is pushed.

Brake Switch Description

The present brake switch is used as an input variable for the ISG function to detect bracke operation. ...

Brake Switch Removal

1. Turn ignition switch OFF. 2. Remove the crash pad lower panel. (Refer to the Body group-"crash pad") 3. ...

See also:

Auto Defogging Sensor (FATC only) Description
The Auto Defogging Sensor is installed on the front windshild glass. The Auto Defogging Sensor senses moisture on the windshild. The air conditioner control module receives the signal from th ...

Adjustment
ETC module learning procedure When installing new ETC module or re-installing it, ETC module learning procedure must be performed. 1. Hold the ignition key o ...

Special Service Tools
Tool (Number and Name) Illustration Use 09200-3N000 Engine support fixture (Beam) Removal and installation of the transaxle. Use t ...

Categories

Copyright © www.kirmanual.com 2014-2026