Kia Rio: Brake Switch Removal

Brake Switch Inspection

1. Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in an ...

Brake Switch Installation

1. Install is reverse of removal. ...

See also:

Removal
1. Turn ignition switch OFF. 2. Remove the crash pad lower panel. (Refer to the Body group - "Crash pad") ...

Rear Torsion Beam Axle Replacement
[Disc Type] 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Vehicle parasitic current inspection
1. Turn the all electric devices OFF, and then turn the ignition switch OFF. 2. Close all doors except the engine hood, and then lock all d ...