Kia Rio Manuals

Kia Rio: Cruise Control Switch: Inspection - Cruise Control System - Engine Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Cruise Control Switch: Inspection

Measuring Resistance
1.
Disconnect the cruise control switch connector from the control switch.
2.
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Function switch
 Terminal
 Resistance
CANCEL
 3 - 4
 180 Ω ± 5%
SET/–
 3 - 4
 330Ω ± 5%
RES/+
 3 - 4
 550Ω ± 5%
ON/OFF
 3 - 4
 880Ω ± 5%
SLD
 3 - 4
 1.44kΩ ± 5%

3.
If not within specification, replace switch.
Measuring Voltage
1.
Connect the cruise control switch connector to the control switch.
2.
Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).
Function switch
 Terminal
 Voltage
CANCEL
 3 - 4
 0.76 ± 0.1V
SET/–
 3 - 4
 1.24 ± 0.15V
RES/+
 3 - 4
 1.77 ± 0.2V
ON/OFF
 3 - 4
 2.34 ± 0.1V
SLD
 3 - 4
 3.0 ± 0.22V

3.
If not within specification, inspect the control switch resistance.
The measuring resistance value is not within specification, replace the switch and measure the voltage again.
4.
If resistance is OK but, measuring voltage is not within specification, inspect the wiring harness and connectors between the switch and the ECM.`
Cruise Control Switch: Installation
1. Install in the reverse order of removal. ...

Emission Control System
...

See also:

TJ Joint Installation
1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

Seat Heater Components
...

Electric power steering
Power steering uses a motor to assist you in steering the vehicle. If the engine is off or if the power steering system becomes inoperative, the vehicle may still be steered, but it will require i ...

Categories

Copyright www.kirmanual.com 2014-2026