Kia Rio: Cylinder Head Assembly - Engine Mechanical System - Kia Rio UB 2012-2024 Service ManualKia Rio: Cylinder Head Assembly

Installation
1. Dowel pin of crankshaft setted about 3° with vertical center line. 2. Align the TDC marks (A) of the CVVT sprockets with the upper su ...

Valve Clearance Inspection And Adjustment
   Inspect and adjust the valve clearance when the engine is cold (Engine coolant temperature : 20°C) and cylinder head is ...

See also:

SS-A Solenoid Valve(ON/OFF) Inspection
1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...

Inspection
Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

Anchor Pretensioner (APT) Installation
1. Remove ignition key from the vehicle. 2. Disconnect the negative (-) cable from battery and wait for at least thirty seconds. ...

Copyright © www.kirmanual.com 2014-2024