Kia Rio: Filler-Neck Assembly Removal
| 1. |
Open the fuel filler door, and then remove the filler-neck assembly
mounting screws (A).
|
| 2. |
Disconnect the fuel filler hose (A) and the vapor hose (B).
|
| 3. |
Remove the filler-neck assembly from the vehicle after removing
the bracket mounting bolt (A).
|
Fuel Filter Replacement
1.
Remove the fuel pump (Refer to “Fuel Pump” in this group).
2.
Disconnect the electric pump wiring connector (A) and the fuel
sender conn ...
Filler-Neck Assembly Installation
1.
Installation is reverse of removal.
Filler-neck assembly bracket
installation nut :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 ...
See also:
Installation
Multifunction Switch
1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the steer ...
Evaporator Temperature Sensor Description
The evaporator temperature sensor will detect the evaporator core temperature
and interrupt compressor relay power in order to prevent evaporator freezing
by excessive cooling.
...
Installation
1.
Combustion seal
2.
Rubber washer
3.
Support disc
4.
O-ring
...
Copyright © www.kirmanual.com 2014-2023