Kia Rio: Description - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Description

Idle Stop & Go (ISG) function automatically switches off the engine when the car is at a standstill if the and starts it again as soon as the brake pedal is released. This not only reduces fuel consumption, it also lowers emissions. Idle Stop & Go (ISG) function also has a built-in sensitivity to driving safety and comfort.
The engine is not switched off if certain conditions relating to safety and comfort have not been fulfilled (For example, when the engine oil is still cold, when the battery is running low or when the outside temperature is below 3°C). It can be deactivated by pressing the ISG OFF switch on the crash pad lower panel.
Sample scenario: switching off the engine at a standstill at a red traffic light or in stop-and-go traffic.
How to use:
1.
Engine Auto-Stop: D-range + brake pedal is pressed.


2.
Engine Auto-Start
(1)
Brake pedal is released.
(2)
Brake pedal is pressed + Manual range (Sports mode)
(3)
Brake pedal is pressed + R range


ISG (Idle Stop & Go) System
...

Operation
1. Vehicle moving. 2. The transmission lever position is D-range. The brake pedal is released. 3. The ...

See also:

Anchor Pretensioner (APT) Description
Front seat belt anchor pretensioner operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat a ...

Transaxle Control Module (TCM) Inspection
TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side c ...

Description
Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ECM groun ...

Copyright www.kirmanual.com 2014-2026