Kia Rio: Engine Oil: Oil And Filter Replacement
| •
|
Prolonged and repeated contact with mineral oil will result
in the removal of natural fats from the skin, leading to dryness,
irritation and dermatitis. In addition, used engine oil contains
potentially harmful contaminants which may cause skin cancer.
|
| •
|
Exercise caution in order to minimize the length and frequency
of contact of your skin to used oil. Wear protective clothing
and gloves. Wash your skin thoroughly with soap and water, or
use water-less hand cleaner, to remove any used engine oil.
Do not use gasoline, thinners, or solvents.
|
| •
|
In order to preserve the environment, used oil and used
oil filter must be disposed of only at designated disposal sites.
|
|
|
1. |
Drain the engine oil.
|
(1) |
Remove the oil filler cap.
|
|
(2) |
Remove the oil drain plug, and drain the oil into a container.
|
|
|
2. |
Replace the oil filter.
|
(1) |
Remove the oil filter.
|
|
(2) |
Check and clean the oil filter installation surface.
|
|
(3) |
Check the part number of the new oil filter is as same
as old one.
|
|
(4) |
Apply clean engine oil to the gasket of a new oil filter.
|
|
(5) |
Lightly screw the oil filter into place, and tighten it
until the gasket contacts the seat.
|
|
(6) |
Tighten it with the torque below.
Tightening torque :
11.8 ~ 15.7N.m (1.2 ~ 1.6kgf.m, 8.7 ~ 11.6lb-ft)
|
|
|
|
3. |
Refill with engine oil.
|
(1) |
Clean and install the oil drain plug with a new gasket.
Tightening torque :
34.3 ~ 44.1N.m (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)
|
|
|
(2) |
Fill with fresh engine oil.
Capacity
Total : 4.0L (4.22US qt, 3.51lmp qt)
Oil pan : 3.3L (3.48US qt, 2.90lmp qt)
Drain and refill in cluding oil filter :
3.6L (3.80US qt, 3.16lmp qt)
|
|
|
(3) |
Install the oil filler cap.
|
|
|
4. |
Start engine and check for oil leaks.
|
|
5. |
Recheck the engine oil level.
|
•
Prolonged and repeated contact with mineral oil will result
in the removal of natura ...
1.
Check the engine oil quality.
Check the oil deterioration, entry of water, discoloring of thinning.
If the quality is visibly poor, replace the oil.
...
See also:
Instrument Cluster Circuit Diagram
[Standard]
[Supervision]
...
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor
and is installed on the surge tank. It senses absolute pressure of the surge
tank and transfers the analog signal propo ...
Removal
1.
Disconnect the battery negative cable from the battery and then
wait for at least 30 seconds.
2.
Turn the steering wheel so that the fr ...
Engine Oil: Oil And Filter Replacement
Engine Oil: Inspection