Kia Rio: Filler-Neck Assembly Installation

Filler-Neck Assembly Removal

1. Open the fuel filler door, and then remove the filler-neck assembly mounting screws (A). 2. Disconnect the fuel filler hose (A) ...

Accelerator Pedal Removal

1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). ...

See also:

Installation
Installation is the reverse of removal. Canister installation bolt/nut: 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft) ...

TJ Joint Replacement
   • Special grease must be applied to the driveshaft joint. Do not substitute with anoth ...

Transaxle Control Module (TCM) Terminal Function
Connector [EGGG-AA] Pin Description Pin Description 22 Shift solenoid D (VFS-OD) 73 Inhibitor switch signal "S4" ...