Kia Rio: Fuel Filter Replacement - Fuel Delivery System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Fuel Filter Replacement

1.
Remove the fuel pump (Refer to “Fuel Pump” in this group).
2.
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).


3.
Remove the head assembly (A) after releasing the cushion fixing clip (B).


4.
Disconnect the fuel tube quick-connectors (C).


5.
Remove the fuel sender (A) in the direction of an arrow.


6.
Disconnect the fuel tube connector (A).


7.
Remove the cut valve (A) after releasing hooks (B).


8.
Remove the reservior-cup (B) after releasing the fixing hooks (A).


9.
Release the fixing hooks, and then remove the pre-filter (A) and the fuel pressure regulator (B).



     
Be careful of O-ring.
10.
Replace new fuel filter.


1. Head Assembly
2. Electric Pump Motor
3. Fuel Filter
4. Fuel Sender
5. Fuel Pressure Regulator
6. Pre-filter
7. Reservoir cup
Fuel Pump Inspection
[Fuel pump] 1. Turn ignition switch OFF and disconnect the negative (-)battery cable. 2. Remove the fuel pump assembly. ...

Filler-Neck Assembly Removal
1. Open the fuel filler door, and then remove the filler-neck assembly mounting screws (A). 2. Disconnect the fuel filler hose (A) ...

See also:

Windshield Wiper-Washer Switch Inspection
Wiper And Washer Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace ...

Brake Switch Inspection
1. Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in an ...

Components Location
1. AVN (A/V & Navigation head unit) 2. Midrange speaker 3. Roof antenna (GPS Radio) 4. Front door speaker 5. Rear door speaker 6. Antenna feeder cable 7. Feeder ca ...

Copyright © www.kirmanual.com 2014-2026