Kia Rio: Front Stabilizer Link Replacement - Front Suspension System - Suspension System - Kia Rio UB 2012-2026 Service ManualKia Rio: Front Stabilizer Link Replacement

1.
Remove the rear wheel & tire

Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)


2.
Remove the stabilizer link (A) loosening the nut (B) and (C).

Tightening torque :
98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)


Front Lower Arm Inspection
1. Check the bushing for wear and deterioration. 2. Check the lower arm for deformation. 3. Check the all bolts ...

Front Stabilizer Link Inpesction
Check the front stabilizer link ball joint for damage. - ­ Torn boot - ­ Opened boot - ­ Displaced ring ...

See also:

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch ...

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the VIS valve connector. 3. Measure resistance between VIS valve ...

Engine oil
Checking the engine oil level 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes ...

Copyright www.kirmanual.com 2014-2026