Kia Rio: Front Wheel Speed Sensor Removal - ESC(Electronic Stability Control) System - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Front Wheel Speed Sensor Removal

1.
Remove the front wheel and tire.

Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.
Remove the front wheel speed sensor mounting bolt (A).

Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)


3.
Remove the front wheel guard.
4.
Remove the front wheel speed sensor cable mounting bolt.
5.
Disconnect the front wheel speed sensor connector, and then remove the front wheel speed sensor.
6.
Installation is the reverse of removal.
Front Wheel Speed Sensor Components
1. Front wheel speed sensor connector 2. Front wheel speed sensor ...

Front Wheel Speed Sensor Inspection
1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground.    ...

See also:

Cruise Control
The cruise control system is engaged by the cruise "ON/OFF" main switch located on right of steering wheel column. The system has the capability to cruise, coast, accelerate and res ...

Road warning
Hazard warning flasher The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle. It should be used whenev ...

Input Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Copyright www.kirmanual.com 2014-2026