Kia Rio Manuals

Kia Rio: Fuel Pump Inspection - Fuel Delivery System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Fuel Pump Inspection

[Fuel pump]
1.
Turn ignition switch OFF and disconnect the negative (-)battery cable.
2.
Remove the fuel pump assembly.
3.
Check motor operation by fuel pump connector (A) connecting power(No.2) and ground(No.4)


Pin No.
 discription
1
 Fuel sender signal
2
 Fuel pump (+)
3
 Fuel sender ground
4
 Fuel pump (-)

[Fuel sender]
1.
Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.


Pin No.
 discription
1
 Fuel sender signal
2
 Fuel pump (+)
3
 Fuel sender ground
4
 Fuel pump (-)

2.
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
Position
 Resistance (Ω)
 Capacity (ℓ)
E
 197 ~ 203
 2.8
 1/2
 64.2 ~ 68.2
 22.3
F
 6 ~ 10
 41.8

Fuel Pump Installation
1. Installation is reverse of removal. Fuel pump plate cover installation bolt : 1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2.17 lb- ...

Fuel Filter Replacement
1. Remove the fuel pump (Refer to “Fuel Pump” in this group). 2. Disconnect the electric pump wiring connector (A) and the fuel sender ...

See also:

Failure Diagnosis
1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed system control is pr ...

Rear Shock Absorber Components
   • Must completely be tigtened at the curb position of vehicle when assemble shock ...

Overhead Console Lamp Inspection
Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the overhead console lamp assembly. ...

Categories

Copyright www.kirmanual.com 2014-2026