Kia Rio: Fuel Pump Installation - Fuel Delivery System - Engine Control / Fuel System - Kia Rio UB 2012-2022 Service ManualKia Rio: Fuel Pump Installation

1.
Installation is reverse of removal.

Fuel pump plate cover installation bolt :
1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2.17 lb-ft)


     
Be careful of fuel pump direction when installing.
Fuel Pump Removal
1. Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line"). ...

Fuel Pump Inspection
[Fuel pump] 1. Turn ignition switch OFF and disconnect the negative (-)battery cable. 2. Remove the fuel pump assembly. ...

See also:

Inspection
Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TP ...

Blower Resistor (MANUAL) Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (A) and then remove the blower resistor (B) after loosening th ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Circuit Diagram
...

Copyright © www.kirmanual.com 2014-2022