Kia Rio: Fuel Pump Removal
| 1. |
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
|
| 2. |
Remove the rear seat [LH] (Refer to “Seat” in BD group).
|
| 3. |
Remove the fuel pump service cover (A).
|
| 4. |
Disconnect the fuel pump connector (A).
|
| 5. |
Disconnect the fuel feed tube quick connector (B).
|
| 6. |
Disconnect the fuel tank pressure sensor connector (C).
|
| 7. |
Disconnect the vapor tube quick-connector (D).
|
| 8. |
Remove the plate cover (E) after removing the installation bolts,
and then remove the fuel pump from the fuel tank.
|
Fuel Tank Installation
1.
Installation is reverse of removal.
Fuel tank band installation
nut:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
...
Fuel Pump Installation
1.
Installation is reverse of removal.
Fuel pump plate cover installation
bolt :
1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2.17 lb- ...
See also:
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the CCV connector.
3.
Measure resistance between the CCV termina ...
Steering Column and Shaft Adjustment
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below and if abnormal symp ...
Brake Switch Inspection
1.
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in an ...
Copyright © www.kirmanual.com 2014-2025