Kia Rio: Head Lamp Leveling Switch Removal - Head lamp leveling Device - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Head Lamp Leveling Switch Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
3.
Remove the crash pad side switch assembly.


4.
Disconnect the head lamp leveling switch connector from lower crash pad switch.
5.
Remove the head lamp leveling switch.
6.
The installation is the reverse of removal.
Head lamp leveling Actuator Installation
1. Install the head lamp leveling actuator by turning the adjusting gear. 2. Install the head lamp assembly. 3. ...

Immobilizer System
...

See also:

35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
Direct control VFS[35R/C] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42) Current value(mA ...

Heater Unit Components
1. Shower Duct (Left) 2. Heater Pipe Cover 3. Mode Control Actuator 4. Mode Control Actuator Bracket 5. Defog mode lever (FATC) 6. Mode Control Main Lever (MANUAL) 7. Vent ...

Copyright www.kirmanual.com 2014-2026