Kia Rio: Steering Column and Shaft Disassembly - Electric Power Steering - Steering System - Kia Rio UB 2012-2026 Service ManualKia Rio: Steering Column and Shaft Disassembly

Key lock assembly
1.
Make a groove on the head of special bolts (A) with a chisel.


2.
Loosen the special bolt using a screw driver and then remove the key lock assembly from the steering column assembly.
3.
Reassembly is the reverse of the disassembly.
Universal joint assembly
1.
Loosen the bolt (A) and then disconnect the universal joint assembly from the steering column assembly.

Tightening torque :
27.5 ~ 29.4N.m(2.8 ~ 3.0kgf.m, 20.3 ~ 21.7lb-ft)


2.
Reassembly is the reverse of the disassembly.

     
Do not disassemble the EPS module from the column shaft.
Steering Column and Shaft Replacement
1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the fro ...

Steering Column and Shaft Inspection
1. Check the steering column for damage and deformation. 2. Check the steering column for damage and deformation. 3. ...

See also:

Compressor Disassembly
1. Remove the RH front tire. (Refer to SS group - “Front Tire”) 2. Remove the engine room RH side under cover. (Refer to EM ...

Lighting control
The light switch has a Headlight and a Parking light position. To operate the lights, turn the knob at the end of the control lever to one of the following positions: (1) OFF position (2) Parking ...

General Service Information
Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work.    The s ...

Copyright www.kirmanual.com 2014-2026