1. |
After loosening the hinge (A) mounting bolt, adjust the hood (B)
by moving it up or down, or right or left.
|
2. |
Adjust the hood height by turning the hood over slam bumpers (C).
|
3. |
After loosening the hood latch (D) mounting bolts and nuts, adjust
the latch by moving it up or down, or right or left.
|
Control System Composition
Fault Diagnosis
Features a fail-safe mechanism that prevents dangerous situations from
developing in the event of a transaxle failure. The limp home mode engages if
the transaxle malf ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the crankshaft position sensor connector (A) ...
Rear Wiper Motor Inspection
Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals ...