Kia Rio Manuals

Kia Rio: Trunk Lid Replacement - Exterior - Body (Interior and Exterior) - Kia Rio UB 2012-2026 Service ManualKia Rio: Trunk Lid Replacement

Trunk Lid Assembly Replacement

     
•
When removing and installing the trunk lid, an assistant is necessary.
•
Wear gloves to protect hands from injury.
1.
Detach the clips, then remove the trunk lid trim (A).
2.
Disconnect wiring (B) and connectors.
3.
After loosening the mounting bolts, then remove the trunk lid (A).
Tightening torque :
6.9~8.8 N.m (0.7~0.9 kgf.m, 5.1~6.5 lb-ft)


4.
Installation is the reverse of removal.

     
•
Make sure the trunk lid locks/unlocks and opens/closes properly.
•
Make sure connectors are connected properly and each rod is connected securely.
•
Replace any damaged clips.
Trunk Lid Latch Replacement
1.
Remove the trunk lid trim.
2.
Disconnect the trunk lid latch connector (C).
3.
Disconnect the cable (B), then loosen the latch assembly (A) mounting bolts and remove.
Tightening torque :
6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)


4.
Installation is the reverse of removal.

     
•
Make sure the trunk lid locks/unlocks and opens/closes properly.
•
Make sure connectors are connected properly and each rod is connected securely.
Trunk Lid Weatherstrip Replacement
1.
Remove the trunk lid weatherstrip (A).

     
•
Do not apply sealant to the body.


2.
Installation is the reverse of removal.

     
•
Install the weatherstrip aligned with canter line (B).
Hood Adjustment
Hood Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left. 2. Adjus ...

Trunk Lid Adjustment
1. After loosening the trunk lid hinge (A) mounting bolt, adjust the trunk lid by moving it up or down, or right or left. 2. Adjust the tru ...

See also:

Temperature Control Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the driver side shower duct (A) after loosening the screw. ...

Components
1. Cylinder head cover 2. Cylinder head cover gasket 3. Cylinder head assembly 4. Cylinder head gasket 5. Camshaft position sensor 6. Camshaft bearing cap 7. Camshaft ...

Curtain Airbag (CAB) Module Description
Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain airbag by us ...

Categories

Copyright www.kirmanual.com 2014-2026