1. |
Place the shift lever into the "N" position.
|
2. |
Remove the air cleaner assembly.
|
3. |
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
|
4. |
Disconnect the inhibitor switch connector (A).
|
5. |
Remove the shift cable mounting nut (B).
|
6. |
Remove the manual control lever (B) and the washer after removing
a nut (A).
|
7. |
Remove the inhibitor switch (A) after removing the bolts (2ea).
|
Room Lamp Inspection
Room Lamp
Remove the room lamp assembly then check for continuity between terminal.
If the continuity is not as specified, replace the room lamp assemlby.
...
Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging pa ...
Rear Hub - Carrier Inspection
1.
Check the hub for cracks and the splines for wear.
2.
Check the brake disc for scoring and damage.
3.
C ...