Kia Rio: Inspection| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the HO2S connector.
|
| 3. |
Measure resistance between the HO2S terminals 4 and 5 [B1/S1].
|
| 4. |
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
|
| 5. |
Check that the resistance is within the specification.
|
Circuit Diagram
RemovalWheel Hub Nut Tightening Sequence
Tighten the hub nuts as follows.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Compression Pressure Inspection
If there is lack of power, excessive oil consumption or poor fuel
economy, measure the compression pressure.
...
Valve Body Installation
1.
Installation is the reverse of removal.
After replacement or reinstallation procedure of ...