Kia Rio: Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

2.

Measure the output voltage of the RPS at idle and various engine speed.

Condition	Output Voltage (V)
Idle	Approx. 1.2
1,500 rpm	2.2 ~ 2.5
6,300 rpm	Approx. 3.0

Circuit Diagram

(M/T) (A/T) ...

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line (Refer to the ...

See also:

Curtain Airbag (CAB) Module Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...

Rear-camera display
The Rear-Camera Display will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R (Reverse) position. This system is a supplemental system that displays ...

Troubleshooting
Problem Symptoms Table Use the table below to help you find the cause of theproblem. The numbers indicate the priority of the likecause of the problem. Check each part in order. ...

Categories

Copyright © www.kirmanual.com 2014-2026