Kia Rio Manuals

Kia Rio: Removal - Rail Pressure Sensor (RPS) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").

     
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).
4.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.
Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

Installation
   • Install the component with the specified torques. • ...

See also:

Inspection
[System Inspection] 1. Disconnect the vapor hose from the intake manifold and connect a vacuum pump to the nipple on the intake manifold. · At Cold Engine [Eng ...

ISG OFF Switch: Inspection
1. Remove the crash pad side switch assembly (A) from the switch panel on the crach pad of the driver's side. 2. Remove the ISG ...

Sunroof Components
1 . Glass panel assembly 2 . Glass panel 3 . Reinforcement glass 4 . Encapsulated glass panel 5 . Wind deflector net assembly 6 . Wind deflector beam 7 . Plate cover [RH] ...

Categories

Copyright www.kirmanual.com 2014-2026