Kia Rio: Inspection - Manual Transaxle System - Kia Rio UB 2012-2025 Service ManualKia Rio: Inspection

Manual Transaxle Oil Inspection
1.
Park the vehicle on a level ground and stop the engine.
2.
Retighten the oil filler plug (A) with a new washer.


3.
Check level with finger.

     
Oil level must be up to fill the hole, if not, add oil until it runs over.


4.
Install filler plug.

Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.8 lb-ft)

Manual Transaxle Oil Replacement
1.
Park the vehicle on a level ground and stop the engine.
2.
Drain the manual transaxle oil after loosening the drain plug (A).


3.
Install the drain plug with new gasket.

Tightening torque:
58.9 ~ 78.5 N.m (6.0 ~ 8.0kgf.m, 43.4 ~ 57.9 lb-ft)

4.
Add new oil through the filler plug hole and, fill it just below the plug opening.

Standard oil: SAE 75W/85, API GL-4
Oil capacity: 1.8 ~1.9L (0.48 ~0.50 U.S.gal., 1.90 ~ 2.0 U.S. qt., 1.58 ~ 1.67 lmp qt.)

Special Service Tools
Tool (Number and Name) Illustration Use 09200-38001,3N000 (Beam) 09200-1P100, 4X000 (Adapter) 09200-2S200 (Supporter) Engine support assembly ...

Manual Transaxle Components
1. Transaxle support mounting bracket 2. Control shaft complete 3. Back up lamp switch 4. Vehicle speed sensor ...

See also:

Power Door Lock Switch Installation
1. Install the power window switch module. 2. Install the door trim panel after reconnecting the relevant connectors ...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...

Specification
Ignition System Ignition Coil Item Specification Primary Coil Resistance (Ω) 0.75 ± 15% [20°C (68°F)] Secondary Coil R ...

Copyright © www.kirmanual.com 2014-2025