Kia Rio Manuals

Kia Rio: Installation - Alternator - Charging System - Engine Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Installation

1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine charging System - "Drive belt tension measurement and adjustment")
Alternator installation bolt:
[12mm (0.47in) bolt]
19.6 ~ 26.5 Nm (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 Ib-ft)
[14mm (0.55in) bolt]
29.4 ~ 41.2 Nm (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 Ib-ft)
Removal
1. Disconnect the battery negative terminal. 2. Disconnect the air compressor connector (A) and the alternator connector (B), and remove th ...

Disassembly
1. Remove the rear cover (A) after removing nuts. 2. Remove the mounting bolts (A) and the brush holder assembly (B). ...

See also:

Filler-Neck Assembly Removal
1. Open the fuel filler door, and then remove the filler-neck assembly mounting screws (A). 2. Disconnect the fuel filler hose (A) ...

Room Lamp Inspection
Room Lamp Remove the room lamp assembly then check for continuity between terminal. If the continuity is not as specified, replace the room lamp assemlby. ...

Door Switch Inspection
1. Remove the door switch and check for continuity between the terminals. ...

Categories

Copyright www.kirmanual.com 2014-2026