Kia Rio: Removal

1.	Disconnect the battery negative terminal.

2.	Disconnect the air compressor connector (A) and the alternator connector (B), and remove the cable from alternator "B" terminal (C).

3.	Loosen the mounting bolts, and then turn the adjusting bolt (A) clockwise to loosen tension.

4.	Remove the drive belt (A).

5.	Remove the alternator (A) after remove the mounting bolts.

Circuit Diagram

...

Installation

1. Install in the reverse order of removal. 2. Adjust the alternator belt tension after installation. (Refer to Engine charging Sy ...

See also:

Hazard warning flasher lighting
The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as po ...

Clutch & Brake
The 6-spd automatic transaxle consists of an overdrive clutch (OD/C), a one-way clutch (OWC), a lower and reverse brake (LR/B), an underdrive brake (UD/B), a 26 brake (26/B), and a 35R clutch ...

Removal
1. Disconnect the battery terminal (A). 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - & ...

Categories

Copyright © www.kirmanual.com 2014-2026