Kia Rio: Installation - On-board Refueling Vapor Recovery (ORVR) valve - Evaporative Emission Control System - Emission Control System - Kia Rio UB 2012-2026 Service ManualKia Rio: Installation

1.
Install in the reverse order of removal.
Removal
1. Remove the fuel pump. (Refer to Engine Control/Fuel System - “Fuel Pump”) 2. Remove the ORVR valve (A) after releasing hooks (B) ...

Roll Over Valve (ROV): Repair procedures
Removal 1. Remove the fuel pump. (Refer to Engine Control/Fuel System - “Fuel Pump”) 2. Remove the roll over valve (A) after relea ...

See also:

TJ Joint Replacement
   • Special grease must be applied to the driveshaft joint. Do not substitute with anoth ...

Ambient Temperature Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the engine room RH side under cover. (Refer to EM group - “Engine and Trans ...

Component Location
1. Headlamp leveling device 2. Headlamp leveling actuator ...

Copyright www.kirmanual.com 2014-2026