Kia Rio: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
|
1. |
Installation is reverse of removal.
Rail Pressure Sensor Installation:
29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Release the residual pressure in fuel line (Refer to the ...
See also:
Valve Body Installation
1.
Installation is the reverse of removal.
After replacement or reinstallation procedure of ...
Rear Hub - Carrier Components
[Drum Type]
1. Rear torsion beam assembly
2. Brake assembly
3. Rear wheel hub assembly
4. Rear brake disc
5. Rear brake disc mounting screw
...
Components Location
1. Engine Control Module (ECM)
2. Manifold Absolute Pressure Sensor (MAPS)
3. Intake Air Temperature Sensor (IATS)
4. Engine Coolant Temperature Sensor (ECTS)
5. Throttle Po ...
Removal
