Kia Rio: Installation
| •
|
Do not reuse the used injector fixing clip.
|
|
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Apply engine oil to the injector O-ring.
|
| •
|
Do not reuse the used injector O-ring.
|
|
| •
|
Do not reuse the used bolt.
|
|
| •
|
When inserting the injector, be careful not to damage
the injector tip.
|
|
| •
|
Do not reuse the support disc.
|
| •
|
Do not reuse the injector rubber washer.
|
| •
|
When replacing the rubber washer, the steal plate (A)
part should be faced the cylinder installation part and the
rubber plate (B) part should be faced the injector body part.
|
|
| •
|
Do not reuse the combustion seal.
|
|
|
1. |
Installation is reverse of removal.
|
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
The injector combustion seal should be replaced new one to prevent leakage
after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...
See also:
Towing
Towing service
If emergency towing is necessary, we recommend having it done by an authorized
Kia dealer or a commercial tow-truck service. Proper lifting and towing procedures
are necessary to ...
Heated Steering wheel Description
Heated pads to grip the steering grip makes the fever.
Heated control unit
Heated pad
Specifications
Item
Specification
Voltage
13.5 V
...
Heater & A/C Control Unit (FATC) Components
Connector Pin Function
Connector
Pin No
Function
Connector
Pin No
Function
A
1
IGN 2
B
17
HI-SCAN (K-L ...
Removal
Replacement