Kia Rio: Installation - Brake Line - Brake System - Kia Rio UB 2012-2026 Service ManualKia Rio: Installation

1.
Installation is the reverse of removal.

     
Use a new washer (A) whenever installing.


2.
After installation, bleed the brake system.
(Refer to Brake system bleeding)
3.
Check the spilled brake oil.
Inspection
1. Check the brake tubes for cracks, crimps and corrosion. 2. Check the brake hoses for cracks, damage and fluid leakage. 3 ...

Brake Pedal
...

See also:

Fuel Pressure Test (Low pressure system)
1. Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line"). ...

Description
Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens or ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch ...

Copyright www.kirmanual.com 2014-2026