Kia Rio Manuals

Kia Rio: Installation - Crankshaft Position Sensor (CKPS) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2026 Service ManualKia Rio: Installation


     
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

     
•
Apply the engine oil to the O-ring.

     
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.
Crankshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A) ...

Camshaft Position Sensor (CMPS)
...

See also:

Back-up Lamp Switch Replacement
1. Disconnect the back up lamp switch connector (A). 2. Remove the back up lamp switch (A). 3. ...

Intake Manifold: Removal and Installation
1. Remove the engine cover. 2. Disconnect the battery negative terminal. Tightening torque : With ...

Starter: Specification
Starter [Non-ISG type] Item Specification Rated voltage 12 V, 0.9 kW The number of pinion teeth 10 Performance [No-load, 1 ...

Categories

Copyright www.kirmanual.com 2014-2026