Kia Rio: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the crankshaft position sensor connector (A) and remove
the sensor (B) after removing the installation bolt.
|
Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification:
Refer to “Waveform”
...
Installation
•
Install the component with the specified torques.
•
...
See also:
Rear Door Adjustment
Glass Adjustment
•
Check the glass run channel for damage or deterioration,
and re ...
Console Replacement
Floor Console Replacement
[M/T]
•
A plastic trim tool is recommended, but if ...
Roof Trim
Components
[General Type]
1 . Roof trim
2 . Sunvisor
3 . Retainer
4 . Assist handle bracket assembly
[Sunroof Type]
1 . Roof t ...
Categories
- Kia Rio Manuals Home
- Kia Rio YB 2017-2026 Owners Manual
- Kia Rio YB 2017-2026 Service Manual
- Kia Rio UB 2012-2017 Owners Manual
- Kia Rio UB 2012-2017 Service Manual
- Downloads
Copyright www.kirmanual.com 2014-2026