Kia Rio: Installation

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. D ...

ISG (Idle Stop & Go) System

...

See also:

Rear Coil Spring Replacement
1. Remove the rear wheel & tire. (Both RH side and LH side) Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb ...

Antenna Installation
1. Install the roof antenna, then connect the cable and the connector. 2. Install the rear roof trim. ...

Rain Sensor Removal
   The rain sensor may not operate properly if contaminated. Protect the rain sensor surface by not removing the cover unti ...