Kia Rio Manuals

Kia Rio: Oil Pan: Removal - Lubrication System - Engine Mechanical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Oil Pan: Removal

1.
Remove the under covers (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)


2.
Drain engine oil.
3.
Using the SST(09215-3C000) and remove the oil pan.



     
•
Insert the SST between the oil pan and the ladder frame by tapping it with a plastic hammer in the direction of arrow.
•
After tapping the SST with a plastic hammer along the direction of more than 2/3 edge of the oil pan, remove it from the arrow around
more than 2/3 edge of the oil pan, remove it from the ladder frame.
•
Do not turn over the SST abruptly without tapping. It be result in damage of the SST.
Engine Oil Flow Diagram
...

Oil Pan: Installation
1. Install the oil pan. (1) Using a razor blade and gasket scraper, remove all the old packing material from the gasket surfaces. ...

See also:

Antenna Coil Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") ...

Front Washer Motor Inspection
Front Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. &nb ...

Starter: Inspection
Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

Categories

Copyright www.kirmanual.com 2014-2026