Kia Rio Manuals

Kia Rio: Output Speed Sensor Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2026 Service ManualKia Rio: Output Speed Sensor Removal

1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)


3.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)" in this group)
4.
Remove the air breather hose (A).
5.
Remove the valve body cover (B).
Tightening torque:
13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.8 ~ 11.6 lb-ft)

     
Always replace the gasket of the eyebolt use new one whenever loosening eyebolt.

     
Remove installation bolts in the engine compartment first and then remove others under the vehicle.


6.
Remove the plate and the detent spring (A) after removing the bolt.
Tightening torque:
11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)


7.
Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

     
Be careful not to damage the harness lock connector.


8.
Remove the valve body assembly (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


9.
Disconnect the input & output speed sensor connector (A).
10.
Remove the input & output speed sensor (B) after removing the bolts (2ea).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Output Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Output Speed Sensor Installation
1. Installation is the reverse of removal.    After replacement or reinstallation procedure of ...

See also:

Audio Remote Control Schematic Diagrams
Circuit Diagram (1) Circuit Diagram (2) ...

Removal
1. Drain the brake fluid through the bleed plug (A). 2. Remove the clutch release cylinder assembly (C) after removing the tube (B) ...

Phone
Before using the Bluetooth® Wireless Technology phone features In order to use Bluetooth® Wireless Technology phone, you must first pair and connect the Bluetooth® Wireless Technology mobile ...

Categories

Copyright www.kirmanual.com 2014-2026