Kia Rio: TPMS Sensor Installation
Sensor Fit
| •
|
Handle the sensor with care.
|
| •
|
Avoid lubricant contact.
|
| •
|
Ensure that the wheel to be fitted is designed for sensor
mount. There should normally be a mark to indicate this.
|
| •
|
Ensure that the valve hole and mating face of the wheel
are clean.
|
|
|
1. |
Slide the sensor-valve unit through the valve hole of the rim.
Hold the sensor against the rim and the rubber grommet against the sealing
surface.
|
|
2. |
Insert the nut over the valve stem and then tighten the nut.

|
|
3. |
Continue to tightening the nut until contact with the rim and
then tighten to 3.5 ~ 4.5Nm.

|
- |
Tighten slowly with quarter turn steps until the
final torque is reached.
|
|
- |
Do not exceed allowed torque.
|
|
- |
Do not use electric or pneumatic tools.
|
|
|
|
4. |
Check that the sensor is firmly attached to the rim.
|
Risk of damage during the tire installation/ removal if
the sensor is not firmly attached to the rim.
|
|
|
5. |
Carry out inflation / pressure correction and then fit valve cap.
|
Change the newly installed sensor mode to Normal Fixed
Base(Low Line) with the 'GDS'.
Mode (Status / option) of the sensor installed to the
vehicle should be Normal Fixed Base (Low).
|
|
|
6. |
Install the tire. (Refer to "Tire Installation")
|
|
7. |
In the case of TPMS sensor failure, TPMS sensor needs learning.
Faulty sensor is replaced new units, conduct learning of TPMS sensors.
|
Repair tire after using the Tire Mobility
Kit (TMK)
When the TPMS warning lamp OFF
1.
Remove the TMK repaired tire, wheel and TPMS sensor.
(Refer to ...
As manual for diagnosis methods by using diagnosis device, the main contents
are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driv ...
See also:
Components Location
Supplemental Restraint System Control
Module (SRSCM)
Driver Airbag (DAB) / Passenger Airbag
(PAB)
Side Airbag (SAB)
Curtain Airbag (CA ...
Input Speed Sensor Description
Input speed sensor (A) is a vital unit that measures the rate of rotation
of the input shaft inside the transaxle and delivers the readings to the TCM.
The sensor provides critical input data ...
Compressor Removal
1.
If the compressor is marginally operable, run the engine at idle
speed, and let the air conditioning work for a few minutes, then shut
the engine off.
...