Kia Rio: Reassembly

Disassembly

1. Remove the rear cover (A) after removing nuts. 2. Remove the mounting bolts (A) and the brush holder assembly (B). ...

Inspection

[Rotor] 1. Check that there is continuity between the slip rings (C). 2. Check that there is no continuity between the slip ...

See also:

Starter: Disassembly
1. Disconnect the M-terminal (A) on the magnet switchassembly. 2. After loosening the 2 screws (A), detach the magnetswitch assembly ...

Water pump: Removal and Installation
Water Pump 1. Drain engine coolant.    System is under high pre ...

Starter: Cleaning
1. Do not immerse parts in cleaning solvent. Immersing the yoke assembly and/or armature will damage the insulation. Wipe these parts with a cloth only. ...