Kia Rio: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
|
| 3. |
Disconnect the connectors and remove the BCM (A) after loosening
the nut and the bolt.
|
Function
Function
Description
Front Washer & Wiper
-
Settings: IGN2 On,
-
Acti ...
Installation
1.
Install the BCM.
2.
Install the crash pad lower panel.
...
See also:
Blower Resistor (MANUAL) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector (A) and then remove the blower resistor
(B) after loosening th ...
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...
Circuit Diagram
(M/T)
(A/T)
...
Copyright © www.kirmanual.com 2014-2024