Kia Rio: Removal - Clutch Release Cylinder - Clutch System - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

1.
Drain the brake fluid through the bleed plug (A).


2.
Remove the clutch release cylinder assembly (C) after removing the tube (B) and bolts (A-2ea).

Tightening torque:
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.9 ~ 15.9 lb-ft)


Components
1. Union bolt 2. Gasket 3. Tube joint 4. Clutch tube 5. Valve plate 6. Valve spring 7. Bleeder screw 8. Release cylinder 9. Return spring 10. Piston 11 ...

Installation
1. Installation is the reverse of removal.    Coat the clutch clevis push r ...

See also:

Anchor Pretensioner (APT) Description
Front seat belt anchor pretensioner operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat a ...

Crash Pad Components
(1) 1 . Main crash pad assembly 2 . Crash pad side cover [LH] 3 . Crash pad side cover [RH] 4 . Fuse box cover 5 . Crash pad lower panel 6 . Knee bolster panel 7 . St ...

Troubleshooting
Symptom Possible cause Remedy Speedometer does not operate Cluster fuse (10A) is blown Check for short and replace fuse Speedometer faulty ...

Copyright www.kirmanual.com 2014-2026