Kia Rio: Front Wiper Motor Inspection - Windshield Wiper/Washer - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Front Wiper Motor Inspection

Speed Operation Check
1.
Remove the connector (A) from the wiper motor.
1. -
2. IGN+
3. Parking
4. High
5. GND
6. Low


2.
Attach the positive (+) lead from the battery to terminal 6 and the negative (-) lead to terminal 5.
3.
Check that the motor operates at low speed.
4.
Connect the positive (+) lead from the battery to terminal 4 and the negative (-) lead to terminal 5.
5.
Check that the motor operates at high speed.

     
Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial car washes. If the blades are not wiping properly, clean both the window and the blades with a good cleaner or mild detergent, and rinse thoroughly with clean water.
Front Wiper Motor Installation
1. Install the wiper motor. 2. Install the crank arm. 3. Install the lower and upper linkage to the wiper motor ...

Front Washer Motor Inspection
Front Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. &nb ...

See also:

Radiator: Removal and Installation
1. Disconnect the battery negative terminal. Tightening torque (-) terminal (without battery sensor): 7.8 ~ 9.8N.m (0.8 ~ 1.0 ...

Turn Signal Lamp (Door mirror) Removal
Door Mirror Turn Signal Lamp 1. Using a screwdriver or remover, remove the mirror (A) from th mirror holder. Becareful not to damage to the clip. ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ( ...

Copyright www.kirmanual.com 2014-2026