Kia Rio: Front Fog Lamps Inspection - Lighting System - Body Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Front Fog Lamps Inspection

Multifunction Switch(Lighting)
1.
Disconnect the negative(-) battery terminal.
2.
Remove the lighting switch of the multi-function switch. (Refer to the multifunction switch)
3.
With the front fog lamp switch, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function switch.


Front Fog Lamp Switch

High Mounted stop lamp Removal


Front Fog Lamps Installation
1. Install the fog lamp. 2. Reconnect the fog lamp connector. 3. Connect the negative (-) battery terminal. ...

High Mounted stop lamp Removal
[4 Door] 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connect (A). 3. Remove ...

See also:

35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Crash Pad Components
(1) 1 . Main crash pad assembly 2 . Crash pad side cover [LH] 3 . Crash pad side cover [RH] 4 . Fuse box cover 5 . Crash pad lower panel 6 . Knee bolster panel 7 . St ...

General Troubleshooting Information
Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Check the battery for damage, state of charge, and cl ...

Copyright www.kirmanual.com 2014-2026