Kia Rio: Heater & A/C Control Unit (MANUAL) Replacement - Controller - Heating,Ventilation, Air Conditioning - Kia Rio UB 2012-2026 Service ManualKia Rio: Heater & A/C Control Unit (MANUAL) Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater & A/C controller (A) from the center facia using a flat-head screwdriver or remover.


3.
Disconnect the connectors (A).


4.
Install in the reverse order of removal.
Heater & A/C Control Unit (MANUAL) Schematic Diagram
...

Heater & A/C Control Unit (FATC) Components
Connector Pin Function Connector Pin No Function Connector Pin No Function A 1 IGN 2 B 17 HI-SCAN (K-L ...

See also:

Water pump: Inspection
1. Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary. 2. Check the bearing for damage, abnorma ...

Components Operations
ECM (Engine Control Module) 1. The ECM(PCM) (A) carries out a check of the ignition key using a special encryption algorithm, which is programmed into the transponder ...

Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop ...

Copyright www.kirmanual.com 2014-2026