1. |
Basically, all measurements in this manual are taken with a tracking
gauge.
|
2. |
When a measuring tape is used, check to be sure there is no elongation,
twisting or bending.
|
3. |
For measuring dimensions, both projected dimensions and actual
- measurement dimensions are used in this manual.
|
Front Hub / Knuckle Inspection
1.
Check the hub for cracks and the splines for wear.
2.
Check the brake disc for scoring and damage.
3.
C ...
Water pump: Removal and Installation
Water Pump
1.
Drain engine coolant.
System is under high pre ...
Temperature Control Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver side shower duct (A) after loosening the screw.
...