Kia Rio Manuals

Kia Rio: Installation - Alternator - Charging System - Engine Electrical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Installation

1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine charging System - "Drive belt tension measurement and adjustment")
Alternator installation bolt:
[12mm (0.47in) bolt]
19.6 ~ 26.5 Nm (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 Ib-ft)
[14mm (0.55in) bolt]
29.4 ~ 41.2 Nm (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 Ib-ft)
Removal
1. Disconnect the battery negative terminal. 2. Disconnect the air compressor connector (A) and the alternator connector (B), and remove th ...

Disassembly
1. Remove the rear cover (A) after removing nuts. 2. Remove the mounting bolts (A) and the brush holder assembly (B). ...

See also:

Ignition Coil: Installation
1. Install in the reverse order of removal. Ignition coil installation bolts: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft) ...

Heater & A/C Control Unit (MANUAL) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the heater & A/C controller (A) from the center facia using a flat-head scre ...

Audio Remote Control Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to the RT group - "DAB and Clock spring ...

Categories

Copyright www.kirmanual.com 2014-2026