1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the accelerator position sensor connector (A).
|
3. |
Remove the installation nuts (B), and then remove the accelerator
pedal module.
|
Fuel Tank Removal
1.
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
...
Thermostat: Components
1. Water inlet fitting
2. Thermostat
3. Heater pipe
4. Water temp control assembly
5. Water temperature sensor
6. Gasket
...
Ignition Coil: Installation
1.
Install in the reverse order of removal.
Ignition coil installation bolts:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
...