Kia Rio: Adjustment
When shift shock is occurred or parts related with the transaxle are replaced,
TCM learning should be performed.
In the following case, TCM learning is required.
| • |
Transaxle assembly replacement
|
|
1. |
TCM learning condition
| A. |
ATF temperature: 40 ~ 100°C (104 ~ 212°F)
|
|
|
2. |
TCM learning procedure
| A. |
Stop learning
Repeat the below shift pattern four times or more with
stepping on the brake.
|
| 1. |
Drive the vehicle through all gears at D range. Drive
from stop to 1st to 2nd to 3rd to 4th to 5th to 6th with keeping
fixed throttle open.
|
| 2. |
Down shift from 6th to 5th, 5th to 4th, 4th to 3rd, 3rd
to 2nd, 2nd to 1st.
|
| 3. |
Repeat the above driving pattern four times or more.
Up-shift throttle open : 15 ~ 25%
|
|
Fault Diagnosis
Features a fail-safe mechanism that prevents dangerous situations from
developing in the event of a transaxle failure. The limp home mode engages if
the transaxle malf ...
See also:
Transaxle Control Module (TCM) Inspection
TCM Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis
ground using the backside of TCM harness connector as TCM side c ...
Radiator: Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, then
install it to pressure tester.
2.
Apply ...
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing ...
Control System Composition
Circuit Diagram