1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub .
|
3. |
Remove the brake caliper mounting bolts , and then hold the brake
caliper assembly (B) with wire.
|
4. |
Remove the brake hose mounting bracket (A) & wheel speed sensor
(B) & bracket (C).
|
5. |
Remove driveshaft nut (A) from the front hub under applying the
brake.
|
6. |
Remove the tie rod end ball joint from the knuckle.
|
7. |
Remove the lower arm (A) from the knuckle.
|
8. |
Disconnect the driveshaft (A) from the front hub assembly.
|
9. |
Loosen the strut mounting bolts and then remove the knuckle assembly
(A).
|
10. |
Install in the reverse order of removal.
|
SS-B Solenoid Valve(ON/OFF) Description
SS-B solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed
at valve body.
...
Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification:
Refer to “Waveform”
...
Components
...