Kia Rio: Removal - Seat Belt Pretensioner - Restraint - Kia Rio UB 2012-2026 Service ManualKia Rio: Removal

1.
Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work.
2.
Remove the seat belt after pushing the lock pin (A).


3.
Remove the door scuff trim.
(Refer to the Body group - "Interior trim")
4.
Remove the center pillar trim.
(Refer to the Body group - "Interior trim")
5.
Remove the upper anchor bolt.
6.
Disconnect the seat belt pretensioner connector (A).


7.
Loosen the seat belt pretensioner mounting bolts (B, C) and remove the seat belt pretensioner.
Components
...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...

See also:

TPMS Receiver Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

General Troubleshooting Information
Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Check the battery for damage, state of charge, and cl ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Description
35R clutch control solenoid valve(35R/C_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 35R clutch. ...

Copyright www.kirmanual.com 2014-2026